How can I use the full range of the freq knob?

[simonbreak]

Hi guys, hoping an Andro guru can help me with this tricky problem.

Both my freq knobs have an annoying issue: only about 2/3rds of their total throw has an effect on the value. In other words, from about 7 o clock to about 9 o clock the value stays at it's minimum, then from 9 o clock to about 3 o clock it ramps from min to max, then from 3 o clock to 5 o clock it just stays at maximum.

I have tried messing with the offset value on the filter page and this didn't fix it. Is there some way I can configure the effective range of the two freq knobs, ideally on a global basis so I don't have to set it for every patch?

Cheers for any help! [sb]

[The Real MC]

The ribbon cables between the pront panel circuit boards need to be re-seated, they oxidize with age and will cause problems like this. MAKE SURE THE CONNECTORS ARE NOT OFFSET WITH PINS OR YOU WILL DAMAGE THE A6!

[simonbreak]

Thanks a lot, will give this a try!