FS: Haible Frequency Shifter boards, mostly stuffed

[Peake]

Board set to build one frequency shifter.

No pics until I find the camera's battery charger, but excepting ICs (note: NO ICs), this is mostly stuffed (five of the twelve dome filter cap/resistor sets are in place, at very close to optimum values- I've saved the values on a chart for reference, and the resistors are not yet soldered if you want to shoot for closer matching to optimum. I'm closer than the specified "loose" tolerance.) 1% resistors in most places; the caps in the allpass aren't matched but are 5% tolerance, so there's room for improvement there if you want it. The power supply section is not stuffed. Includes polystyrene caps for the oscillator. No headers. Includes IC sockets (already soldered).

Make an offer... I prefer paypal. Thanks for looking, and thanks to Mr. Haible for the project!

[Peake]

A kick to mention that it's still available, and perhaps a Wogglebug PCB or two as well (also partially stuffed). I'm mostly offline these days so drop me a PM and wait patiently (or not). Thanks.